Witryna14 sty 2024 · Der Vorschlag ergibt sich doch aus @ gafu 's Antwort: alles, was Elektronik und Netzteil ist nach draußen und neu Verkabeln in Richtung Thermistor, Heatblock, Endstops und Motoren. Wenn Du die Temperatur steuern willst, dann geht das wohl am einfachsten - nicht notwendigerweise am genauesten - mit zwei Ventilatoren: einer, … WitrynaA single 5015 is fine, but I prefer to run dual 5015 with HeroMe6 at 50% or under so they are much quieter, the added weight of the extra fan is not really an issue. Vote. Reply. …
Reversed Z axis after firmware update. : r/ender3v2 - reddit
WitrynaEnder 3 Pro, using Esun ABS+ at 300°C Nozzle and 100°C Bed. Linear Rails on X and Y, some OMC stepper on X (could remain stock for this) and LDO 2504AC on Y (crucial) … WitrynaHere are my steps: Install BL Touch. Manually level bed using 9-point grid & paper method (this works for me) Auto-home. Measure distance needed to be level with … bon bon chic warminster
HomTom HT6 – test smartfona, który wytrzymuje tydzień bez …
WitrynaEnder5+ With speeddrive BMG. I dont know what it is, My printer works fine but I have been unable to find a decent (other than the good for now) duct for my machine. Every single part I print that is supposed to fit and ender5+ doesnt fit. Many put incredible presure on the heater and thermistor wires, In one case breaking them off on me. WitrynaHi all,I'll spare you my biography but in short I've had hell trying to get my Ender printing consistently. It has worked from time to time but I've had to move it and mod it (buck converters) to shush the fans. It's worked fine with the herome6 mount and fans, but only without ABL. Rig is Ender 3, SKR mini v3, HeroMe6 mount, Geetech 3d touch. WitrynaI recently installed dual 5015 fans on my ender 5 plus. I did PID tune, 10 cycles in total via PronterFace. When I select a file to print the fans are too strong and result in a … bon bon children\u0027s wear tyldesley